gasragrid.blogg.se

Geomodel common building feature sizes
Geomodel common building feature sizes












While brick veneer remained popular, other claddings included rusticated weatherboard, asbestos-cement planks or sheets, concrete block, plastic interlocking weatherboards, plywood, board and batten, hardboard, pebble-coated steel vertical profiled panels, metal (single) interlocking weatherboards, and moisture resistant particleboard. Many different types of wall cladding were used.

GEOMODEL COMMON BUILDING FEATURE SIZES WINDOWS

With lower-pitch roofs, the roof space access was limited when a level ceiling was installed, and was non-existent for skillion roofs.Įaves were wider than in the 1950s-60s, often providing the only protection to doors and windows as there was often no defined porch or veranda (though exterior doors were sometimes located in a shallow recess to give some shelter). Many 1970s houses had gable trussed roofs, often with skillion construction over living areas.ĭutch gables were also common on a number of spec-built homes, while other roof forms used were the mansard, reverse mansard, and the mono pitch or lean-to. For example, it was common in the Wellington region to have unequal pitched roofs or steeply pitched roofs and shed dormers to give sufficient upstairs headroom. However, there were a number of exceptions. Roof pitches during the 1970s and early 1980s were typically 12-15°. It was popular because it was relatively cheap to build and was often found as a beachside holiday home or as an alpine lodge. It consisted of a steeply-pitched roof that eliminated the need for external walls on two sides of the building. The A-frame house was another style that flourished briefly in the 1970s. the mansard-roofed dwelling, often built with a skillion roof and dormer windows to allow the roof space to be developed (Figure 5).contemporary style with skillion roofs and glazing to gables.Spanish or Mediterranean style with arches and stucco cladding.ranch style with exposed rafters and roof beams.colonial style, which generally had a bay window off the main living area, windows with smaller panes of glass and shutters each side of the window.While following a prescribed plan layout, they were built in a range of styles that included: Some of these houses were placed on sites that had an orientation and contour that was not suited to the plan, with decks and bridges being used to make the house fit the site.

geomodel common building feature sizes

Many houses were based on standard plans available from books, sometimes produced by building suppliers. A variety of claddings was used, with rusticated weatherboards common. Though a range of styles was available, houses of this era typically had relatively low pitch gabled roofs with wide eaves, and aluminium windows and sliding doors.












Geomodel common building feature sizes